1、我們必須要保持裝載機發電機清潔，當因觸點間沾有灰塵或其它原因不能閉合時，發電機電壓將隨轉速升高而升高。要將裝載機配件的護板上的小氣孔的硬標膠薄體和塑料薄體，以防落入蓄電池內的雜質附在極板上造成短路。
We must keep Shandong loader generator cleaning, when the contact is stained with dirt or other reasons can not be closed, the generator voltage will vary with the speed increased. Hard rubber thin body and a plastic thin body to shield the loader accessories on the small pores, to prevent falling into the impurity in the accumulator of the short circuit caused by the plate.

2、對于裝載機配件來進行一個徹底的更換，乳溝是有蓄電池或者是有無蓄電池在進行作業的時侯，那么你們是必須要嚴格的保持負極搭鐵，否則會燒壞二極管。
For Shandong loader accessories to make a thorough change, cleavage is a battery or there is no battery in operation time, then you must be strictly maintained negative ground, otherwise it will burn diode.

3、當你們?cè)跈z修山東裝載機的時候應該要注意，將發電機高速運轉時，不要突然卸載，否則也會燒會二極管。
When you loader in the maintenance of Shandong should pay attention to, the generator is running at high speed, not sudden unloading, otherwise it will burn will diode.

4、當遇到裝載機的發動機熄火后，應立即將電鎖鑰匙拔到零位或取下，否則蓄電池將長期放電，從而造成電池虧電，磁場繞組燒壞。
When Shandong met the loader engine flameout, should immediately lock keys to zero or remove the battery,otherwise will be long-term discharge, thus cause the battery power loss, magnetic field winding.