1、裝載機http://m.hpize.cn/的發動機啟動后，應立即減小油門，使發動機處于怠速運轉狀態，檢查此時的發動機油壓力，確保機油壓力不低于98kpa，裝載機發動機啟動后，不應立即進行全負荷運轉，應當使發動機怠速運轉5分鐘后，然后中速空載運轉加熱，當冷卻液溫度達60℃以上時，才允許提高到最高轉速，投入滿負荷工作。
After the loader engine is started, should immediately reduce the throttle, so the engine is idling state, this time to check the engine oil pressure, oil pressure to ensure that not less than 98kpa, loaders after the engine starts,should immediately conduct a full load operation, should enable the engine to idle for 5 minutes, then heating load running speed when the coolant temperature reaches above 60 ℃, up to the maximum speed allowed, into full capacity.

2、應緩慢增減裝載機發動機的轉速和符合，特別是對剛啟動著的發動機，不允許猛轟油門高速運轉。
Should slowly decrease loader engine speed and load, especially just started the engine, Meng throttle does not allow high-speed operation.

3、裝載機http://m.hpize.cn/發動機運轉時，應經常檢查機油壓力和冷卻液溫度，在發動機正常工作期間冷卻溫度一般在85-95℃左右，機油壓力應在294kpa-490kpa，任何情況下機油壓力不能低于98kpa，否則應及時查明原因并排除故障。
When the engine is running loaders should always check the oil pressure and coolant temperature, engine during normal working cooling temperature is generally around 85-95 ℃, the oil pressure should be at 294kpa-490kpa, oil pressure

under any circumstances can not be less than 98kpa, otherwise should promptly investigate the cause and troubleshooting.