濟南裝載機日常作業都需要油的潤滑，那么裝載機在安裝時應該如何防治油液的污染，現在由永保機械的有關專家給大家介紹一下。
1、濟南裝載機液壓泵的吸油口應安裝粗濾器，且吸油口處應距油箱底部一定距離；
Jinan loader hydraulic pump Suction strainers should be installed, and the suction mouth should be a certain distance from the bottom of the tank;
2、濟南裝載機出油口處應安裝高壓精濾器，且過濾效果應符合系統的工作要求，以防污物堵塞而引起液壓系統故障；
Jinan loader should be installed at the oil port high pressure fine filter, and the filter effect should be consistent with the system requirements for the work to prevent dirt clogging caused by the hydraulic system failure;
3、濟南裝載機的液壓油箱隔板上應加裝過濾網，以除去回油過濾器未濾去的雜質。
Jinan, the filter should be installed on the hydraulic tank partition loader to remove the oil filter is not filtered back to impurities.
4、濟南裝載機液壓缸上應安裝金屬防護圈，以防污物被帶進缸內，并可防止泥水和光輻射對液壓缸侵蝕而引起泄漏；液壓元器件安裝前應檢查、清理干凈其內部的鐵屑及雜質；

Jinan loader should be installed on thehydraulic cylinder metal protective ring to prevent dirt being brought into the cylinder, optical radiation and prevent mud and erosion caused by the hydraulic cylinder leakage; hydraulic components should be checked prior to installation, clean the inside of the iron debris and impurities;
5、定期檢查液壓油，一旦發現油液變質、泡沫多、沉淀物多、油水分離等現象后應立即清洗系統并換油。新油加入小型裝載機的油箱前應經過靜置沉淀，過濾后方可加入，必要時可設中間油箱以進行新油的沉淀和過濾，確保油液的清潔。
Regularly check the hydraulic oil, once discovered oil deterioration, foam and more and more sediment, oil and water separation phenomenon should immediately wash system and oil changes. Small loader before adding new oil tank should be standing after sedimentation, filtration before adding, if necessary, can be set for the middle of the tank sedimentation and filtration of new oil to ensure clean the oil.

濟南裝載機：http://m.hpize.cn/